Suggested applications: Presses, Log Splitters, Clamping Units and Compactors. Model # CBNA 16.5/3.6JL. 5.88 L without shaft. 3 -3/8 across mounting surface. Minimum 9.5 HP or larger gas engine, direct drive only, horizontal shaft (can be mounted vertical or horizontal).For use with open center hydraulic systems only. Low Pressure: both stages working. High Pressure: 16.5 gpm stage drops out and 3.6 gpm stage is pumping. 4 holes spaced 2 on center. Rotation is clockwise (looking from the motor to the pump /shaft face). Flow rates on the hi-low tandem pumps are 0.256 cu in/rev on the low flow and 0.793 cu in/rev on the high flow pump. This 2 stage pump can give you much faster cycle times and higher possible pressures with a small engine.
Model GP-CBN is a HI/LO hydraulic gear pump with 12 different displacement combinations with maximum pressures of 900 psi for the low pressure pump and 3000 psi for the high pressure. The change from LO to HI pressure is automatic with the LO side pressure pre set from 400 psi to 900 psi.The HI/LO section of the pump is all aluminum and the end plates are cast steel. Applications for the HI/LO pump are log splitters, presses etc where rapid movement of the cylinder at low pressure is required prior to automatically switching to the high pressure mode to meet load requirements. The item "19 GPM Hydraulic Log Splitter 2 Stage Gear Pump, Faster replacement for 16 gpm" is in sale since Tuesday, December 1, 2020. This item is in the category "Business & Industrial\Hydraulics, Pneumatics, Pumps & Plumbing\Other Hydraulics & Pneumatics". The seller is "ronawhitsell-88" and is located in Flemington, New Jersey.
This item can be shipped to United States.